QBU 3.14.09

Shaped foils on keel, skeg, finished gluing knuckle stringers and tapering them. Also filed and trimmed keel slots to for BH's 3 and 4. Finished coating stems and skegs.


Still to go:

1. End-grain edge coating of everything not done, with silica.
2. Abrade all fillet surfaces.
3. Add vents to BH 6 (or 3)
4. Mark hull end lines on all stems

New stuff thought of before assy:
1. Get screws and washers
2. Clear a space
3. Do the layout for the rudder lashings before going 3D


After that, we assemble the hulls and do filleting until the new wood arrives.
No pictures again, my camera is a pain in the ass to use for a few shots, it's set up to take 100 at a time in photoshoots, not shoot quick progress shots.